Turning the stabilizing feet
To rotate the front feet, complete the following steps.
Feet
1. Carefully position the server on a flat surface. The feet should hang over the
edge of the flat surface to ease removal.
2. Press in on the clips to hold the feet in place; then, pry the feet away from the
server. In some cases, you might need a screwdriver to pry the feet from the
server.
Feet
3. Reinstall the feet in the opposite location. The tab on the feet should extend
beyond the edge of the server.
80 ThinkServer TD100 and TD100x: Hardware Maintenance Manual
To Next Page
Loading...
Need help?
General