60 Information SET-02
17 Radio And Television Interference
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio interference energy and, if not installed and
used in accordance with the instructions, may case harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet or on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
You may also find helpful the following booklet, prepared by the FCC:
“How to Identify and Resolve Radio-TV Interference Problems.” This
booklet is available from the U.S. Government Printing Office,
Washington D. C. 20402.
Changes and modifications not expressly approved by the manufacturer
or registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commissions rules.
18 Warranty
Lenz GmbH does everything it can do to ensure that its products
are free from defects and will operate for the life of your model
railroad equipment. From time to time even the best engineered
products fail either due to a faulty part or from accidental mistakes
in installation. To protect your investment in Digital Plus products.
Lenz GmbH offers a very aggressive 10 year Limited Warranty.
Year One: A full repair or replacement will be provided to the
original purchaser for any item that that has failed due to
manufacturer defects or failures caused by accidental user
installation problems. Should the item no longer be produced and
the item is not repairable, a similar item will be substituted at the
manufacturers discretion. The user must pay for shipping to an
authorized Lenz GmbH warranty center.
To Next Page
Loading...
Need help?
General