Information SET-02 7
DIGITAL plus
0
M
In order to switch on the light function of the locomotive decoder, press
the key "0
M
". Press the key once and you will turn on the light, press it
again and you will turn it off. With LH200 you can control up to 9
functions in locomotive decoders.
You have just learned the most important things that you need to
know for the general operation of your digital controlled model
railway. In the next section you will learn about further functions that
your SET-02 has to offer.
3 SET-02 Capabilities Overview
In this section you will learn :
- the range of functions of SET-02
- the possibilities which this range of SET-02 functions opens up
to you in controlling your model railway
The use of the SET-02 functions is explained in detail at the end of
this section.
In SET-02 the LH200 Knob based Engineer's Throttle works
as both an input device and command station at the same
time. It produces the track format, which is amplified by the
power station (LV200) and sent to the tracks. This is why the
LH200 has to be connected to LV200 at all times during
operation.
3.1 Range of possible addresses for your locomotives
With SET-02 you may control any 4 digit locomotive address. This
means that a locomotive address can have any value from 1 to
9999.
Address 0 is special. With address 0 you control a non-decoder
equipped conventional locomotive on your DCC layout. Using a
conventional locomotive (a locomotive without decoder) and a digital
locomotive (with the decoder included with this SET) you are
immediately in the position to starting digital operation with two
locomotives!
You will find more information about selecting the locomotive you
wish to control from the LH200 in the section which starts on
page 14.
To Next Page
Loading...
Need help?
General