Configuration of analog and digital setpoints and actual values
Setpoints via a bus system
10
Function library
10.8
10.8.7
L
10.8-16
EDS82EV903-1.0-11/2002
With keypad XT EMZ9371BC
The setpoint can be directly selected under C0140:
1. Select C0140 in the menus.
2. Set the setpoint using y or z
Drive performance
l If the controller is enabled, the changed setpoint has a direct effect on the
drive.
l The setpoint is saved when the controller is inhibited. After the controller
has been enabled, the drive accelerates or decelerates to the saved value.
l The setpoint selected via keypad has an effect on setpoint 1 (NSET1-N1)
and setpoint 2 (NSET1-N2). If you want to select different setpoints via
keypad:
– Separate the linkage of NSET1-N1 and NSET1-N2 with analog input
signals (C0412/1 = 0 and C0412/2 = 0).
– Now you can set NSET1-N1 in C0046 and NSET-N2 in C0044 with the
keypad.
l Set C0140 = 0, if the setpoint is not given under C0140, otherwise the drive
may start immediately when the controller is released.
10.8.7 Setpoints via a bus system
Setpoints or actual values can be preselected for FIF by means of a bus function
module or AIF by means of a bus module.
A detailed description can be found in the documentation for the modules.
Setpoint selection with keypad
XT EMZ9371BC
Drive performance when
selecting the setpoints via
keypad
Tip
To Next Page
Need help?
General