7.3
Solving General Printing Problems
If you have any problems with the operation of your printer, see the following table for
suggested solutions.
Problem
The printer does not
print.
Possible Cause
The printer is not receiving
power.
Your printer is not selected
as the default printer.
Check the printer for the
following:
The printer may be in
manual feed mode or out
of print media. (The
light is on or flashing.)
The connection cable
between the computer and
the printer is not
connected properly.
The connection cable
between the computer and
the printer is defective.
The port setting is
incorrect.
TROUBLESHOOTING
Solution
If no lights are on, check the power
cord connections. Check the power
switch and the power source.
Select Lexmark E210 as your default
printer.
• The printer cover is not closed.
• Print media is jammed.
• No print media is loaded.
• Print cartridge is not installed.
• Printer system error occurs. Contact
a service representative.
Add print media to the manual input
tray, and press the button on the
printer control panel to start printing.
Disconnect the printer cable and
reconnect it.
If possible, attach the cable to another
computer that is working properly and
print a job. You may also try replacing
the printer cable.
Check the Windows printer setting to
make sure that the print job is sent to
the correct port (for example, LPT1).
If the computer has more than one
port, make sure the printer is attached
to the correct one.
To Next Page
Loading...
Need help?
General