EasyManuals Logo
Home>Lightware>Extender>UMX-OPT-TX150R

Lightware UMX-OPT-TX150R User Manual

Lightware UMX-OPT-TX150R
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
UMX-OPT-TX150R
User’s Manual
Section 6. Operation of UMX-OPT-TX150R Page 29 / 107
6. Operation of UMX-OPT-TX150R
6.1. Front and rear panel LEDs
VIDEO Status LEDs (DVI-D, DVI-A, VGA, HDMI) is
ON when the video input port is selected and there is a valid video signal on it.
BLINKING when the video input port is selected and there is no valid video signal on it.
OFF when the video input port is NOT selected. Another port is active or there was a
disconnect command.
AUDIO Status LED (DVI-D, Audio 1, Audio 2, HDMI, S/PDIF) is
ON when the audio input port is selected.
OFF when the audio input port is NOT selected. Another port is active or there was a
disconnect command.
HDCP LED is
ON when the incoming video signal is HDCP protected.
OFF when the incoming video signal is NOT protected.
Autoselect LED is
ON when the autoselect mode is selected and a valid video signal is found.
BLINKING when the autoselect mode is selected and video signal searching is in progress.
OFF when another video input port (DVI-D, DVI-A, VGA, HDMI) is selected.
LINK LED is
ON when the TX and the RX (or OPT-IB) are connected to each other via the optical cable
and they can communicate.
OFF when the TX and RX (or OPT-IB) are not connected or they CANNOT communicate.
RS-232 LED is
ON when the RS-232 working mode is CONTROL.
OFF when the RS-232 working mode is PASS.
KVM LED is
always OFF in this firmware version. USB HID (KVM) extension is under development, only
available later.
EDID LED
is ON when there is a valid EDID on the currently active input port.
is BLINKING FAST continuously when there is an INVALID EDID on the currently active
input port.
BLINKS FAST THREE TIMES when EDID learning was unsuccessful.
BLINKS SLOW THREE TIMES when EDID learning was successful.
PWR LED is
ON: when the transmitter unit is powered with +5V DC and ready to use.
BLINKING: when the transmitter unit is powered but an error occurred.
OFF: when the transmitter unit is NOT powered or out of order.

Table of Contents

Other manuals for Lightware UMX-OPT-TX150R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lightware UMX-OPT-TX150R and is the answer not in the manual?

Lightware UMX-OPT-TX150R Specifications

General IconGeneral
BrandLightware
ModelUMX-OPT-TX150R
CategoryExtender
LanguageEnglish

Related product manuals