Lightware UMX-OPT-TX150R User Manual

UMX-OPT-TX150R
User’s Manual
Section 6. Operation of UMX-OPT-TX150R Page 35 / 107
6.7. Audio input in Autoselect mode
Info: DVI-D or HDMI embedded (either of them, depends on the result of the video autoselect),
S/PDIF and Analog audio 2 inputs are available for audio autoselect. Analog audio 1
input can be choosen manually only.
The audio Autoselect mode can work in ten ways:
Figure 6-9. Autoselect for audio inputs
6.7.1. Static select
The device select one video input during the video Autoselect procedure. If the result was
a digital video input (DVI-D or HDMI) its embedded audio input will be selected. (DVI-D
embedded audio to the DVI-D video or HDMI embedded audio to the HDMI video input.)
If the DVI-A video input was selected in Autoselect mode the Analog audio 1 input will be
selected. If the VGA video input was selected in Autoselect mode the Analog audio 2
input will be selected. This video and audio input assigning will be occurred even if there
is no valid audio signal on the input. The selected audio input will be active until a new
result of video Autoselect or the device exits from the Autoselect mode.
Figure 6-10. Static priority audio selection flowchart
Fix select
Priority
AUDIO AUTOSELECT
Static select
Priority detect
E – S - A2
Non-priority
First detect
Priority detect
S – E – A2
Priority detect
E - A2
Priority detect
S – A2
Fix select
Embedded
Fix select
Analog 1
Fix select
Analog 2
Fix select
S/PDIF
Legend for Priority:
E: Embedded
S: S/PDIF
A2: Analog audio 2
Result of VIDEO Autoselect
DVI-D VIDEO
DVI-D
embedded
DVI-A VIDEO
Analog
audio 1
HDMI
embedded
HDMI
VGA
Analog
audio 2

Lightware UMX-OPT-TX150R Specifications

General

Brand	Lightware
Model	UMX-OPT-TX150R
Category	Extender
Language	English