- 94
english
Operating Loewe equipment
Using the remote control for the TV mode of the TV set
Press the TV button, the display above it will light for
approx. 5 seconds.
Using the remote control for a Loewe recorder
Press the REC button, the display above it will light for
approx. 5 seconds.
Using the remote control for a Loewe player
Press the DVD button, the display above it will light for
approx. 5 seconds.
Using the remote control for the radio mode of the TV set
Press the AUDIO button, the display above it will light for
approx. 5 seconds.
As long as a button is pressed, the display of the selected operating mode
lights up (TV – REC – DVD – AUDIO). This allows you to check which op-
erating mode the remote control is set to every time you press a button.
The factory setting of the buttons REC, DVD and AUDIO is described above
(see also table in right hand column). The assignment of the buttons can
be changed to suit the existing accessory devices (see right hand column).
Setting the remote control for other Loewe devices
You can operate various Loewe devices with the remote control. The
device keys REC – DVD – AUDIO can be reassigned to operate various
Loewe devices.
Press the required device buttons and the STOP button
simultaneously for 5 sec. until the corresponding LED
display flashes twice.
Then enter the two-digit device code from the list below.
Device Code Factory setting
Loewe ViewVision 8106 H 10
Loewe ViewVision, Centros 21x2 12
Loewe ViewVision DR
+
DVB-T 13 REC
Loewe Auro 2216 PS/8116 DT 14
Loewe BluTech Vision 15
Loewe Soundprojector 17
Loewe TV - Digital radio 19 AUDIO
Loewe Mediacenter 20
Loewe BluTech Vision Interactive 21 DVD
Loewe AudioVision 24
Loewe Individual Sound Projector SL 25
Apple IR codes 26
Resetting to factory setting 99
The associated LED display flashes twice.
➠ The codes shown here only apply for direct operation of the acces-
sory device.
External devices
To Next Page
Loading...
Need help?
General