LS tractor MT2 Series User Manual

5 -20
(6) Air cleaner (Dry type)
① Cleaning filter element
 Remove the cover and pull out the primary filter
element straight out in the right figure.
 When cleaning the element in the working field,
tap the element by hand to remove the dust.
▶Do not tap the element on a
hard place when cleaning it.
▶if the element is cracked,
change it with a new one.
Notice
 If the dust is not removed by tapping, use the
compressed air {less than 500kPa (5bar, 72psi)}
from inside to outside as shown in the right
figure to remove the dust and dirt. And clean
inside the filter element with a clean damp cloth.
(5) Engine coolant
 See chapter 5-10-(1), “Replacement of Engine coolant ” in this manual. (See page 5-37)
(Pressurized air)
Cover
Primary filter
element
Evacuator
valve
②
Assembling filter element

Clean the inside of the air cleaner housing using a clean damp cloth.

Check if there is damage inside the filter element by using a light. If there is a tiny crack or small hole
in the filter element or the gasket is damaged, replace it with a new one.

Insert the filter element deeply into the filter housing.

Remove the dust of the evacuator valve and clean the inside of the cover.

Assemble the cover with the evacuator valve facing downwards.
▶
Do not assemble a wet filter element.
▶
Do not dry the wet filter element by using compressed air. It may cause damage to
the filter element.
▶
Do not start the engine or close the hood if the filter element is not assembled.
Notice

LS tractor MT2 Series Specifications

General

Brand	LS tractor
Model	MT2 Series
Category	Tractor
Language	English