To Next Page

To Previous Page

5 -30

(2) Replacing Hydraulic Oil Filter

① Main suction filter

 Stop the tractor on a level surface, engage the

parking brake, lower the implements, stop the

engine and cool down the tractor sufficiently.

 The filter is attached on the rear side under the

right-hand floor.

 Carefully clean around the filter and set a clean

container under the filter.

 Coat clean hydraulic oil on the packing of new

filter and check the packing is placed well in the

groove.

 Turn the oil filter counter-clockwise to remove it

with a filter wrench.

② HST filter (HST only)

 This filter is attached on the rear side under the

left-hand floor of the HST models.

 Replace the HST filter according to the same

procedure of the Main suction filter.

▶ Make sure to stop the engine before loosening the oil filter.

▶ If the filter or oil is very hot, it may cause serious burns. After cooling down the

tractor sufficiently, replace the filter.

▶ Do not throw the exhausted waste oil to any place. This may pollute the soil and

water seriously and also is prohibited legally. If violating, you would be responsible

for that by civil or criminal case.

Warning

 Turn the new filter clockwise to assemble it until the packing makes contact with the mounting

surface. Tighten the filter from ¾ to 1 turn more after the contact.

 Add new oil and run the engine at low idle rpm, and check any leakage.

 Check the oil level. If necessary, add new oil. For oil specification, see chapter 5-3, “Lubricants and

Capacity” or the last page in this manual.

Loosen

Tighten

HST filter

Main

suction filter

Loosen

LS tractor MT2 Series User Manual

Questions and Answers: