4 -6
(2) How to drive
2. Set the engine speed more than 1500
rev/min.
3. Place the range gear shift lever on a
suitable position.
4. After pressing down the brake pedals,
release the parking brake.
5. Press the HST pedal down slowly to move
the tractor.
HST type
Position control
lever
Range gear lever
Throttle lever
HST pedals
Cruise control lever
Cruise drive
Parking brake lever
Brake pedals
▶ For driver’s safety, if the operator leaves the driver’s seat without safety measures,
the engine shall be stopped automatically. For further information, see chapter 2-1-
(2) in this manual.
▶ When driving or working with the HST model, operate it more than 1500 rev/min
for stability of the hydraulic system.
▶ Press down the HST pedals slowly to prevent a sudden start of the tractor.
Caution
6. To enter the cruise control mode, move the
cruise control lever upward while driving
forward. To exit the mode, press down the
brake pedals or HST forward pedal deeper
once, the cruise control drive will be quitted.
Do not push down the cruise control lever to
quit the cruise drive mode. It may cause a
failure of the cruise linkage system.
1. Lift up all the implements (front/middle/rear)
from the ground after starting engine
To Next Page
Loading...
Need help?
General
