To Next Page

To Previous Page

1 -39

(1) Preparation for storage

※ Wash your tractor cleanly and follow the

procedure as below.

 Apply grease or lubricant oil or spray paint to the

non-painted metal to avoid corrosion. Keep the

tractor in a covered, dry and well-ventilated

place.

Temperature : 10℃ ~ 35℃ (50℉ ~ 95℉)

Humidity : 45% ~ 70%

 Place all controls, including electrical switches,

in neutral position and apply the wheel chocks to

the tires and disengage the parking brake.

 Check the lubricant level of each parts and if the

engine oil has exceeded 100 hours of work,

change the oil and run the engine for 5 minutes

at idle rpm.

 Drain engine coolant completely. If the engine

coolant is anti-freeze solution, it is not necessary

to drain but check its density.

 Fill the fuel tank full with fuel.

 Loosen all drive belts and clean the air cleaner.

 Loosen the rubber plug (if fitted) under the clutch

chamber to drain water.

 Remove the battery, clean the cover and smear

the terminals with grease. Place the battery in a

ventilated place not less than 10°C (50°F) and

away from direct sunlight.

 Remove the lift-rod and place the lift-arm to the

highest position to lubricate the lift cylinder.

Lift rod

Lift arm

 If possible, fit stands or other suitable supports

under the axles to raise the wheel off the ground.

And let the air out of the tires. If not, check the

tire pressure from time to time.

 Remove the ignition key.

 Cover the tractor with a non-water-proof cover.

 If the implements are attached, lower the

implements on a support off the ground.

1-3. Long-term storage

LS tractor MT2 Series User Manual

Questions and Answers: