5 -24
(2) Changing Transmission oil
z Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.
z Set container under the drain plugs and remove
drain plugs under the transmission and drain oil
completely.
z Clean metal powder stuck to the drain plugs and
tighten drain plugs again with new cooper seals.
z Add new oil until the oil level is between “MIN”
and “MAX” marks of the oil gauge.
z
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
5-11. Every 500 hour check
(1) Changing Front axle oil (4WD)
z Stop tractor on a level surface and apply parking
brake.
z Clean around oil filling inlet and drain plugs.
z Remove Both LH and RH drain plugs and oil
gauge to drain oil completely.
z Tighten the drain plugs with new copper seals.
z Add new oil into the oil filling inlet.
z Check if the oil level is between “MIN” and “MAX”
marks after about 5 minute later.
z Tighten the oil gauge.
z
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
▶ The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
Drain plugs
Oil filling inlet & Oil gauge
Oil filling inlet
& oil gauge
<Oil gauge >
High
Low
Drain plugs
Cooper seals
To Next Page
Loading...
Need help?
General
