OPERATION
AVTMTTR100-ENG Rev 6 Nov 2015
75
Using COMLink Program
COMLink program provides the operator interface for:
transferring readings from TTR to a PC
viewing test data
printing out test reports
creating transformer test results database
Test data stored in the internal memory of the TTR100 test set may be
transferred to a PC. COMLink program supplied with the TTR provides the
operator interface for transferring stored data from the TTR to the PC. With this
software the user can print out test reports from the PC and save the test data as
a (.txt) file or into the database incorporated into the COMLink Upload software.
With these two file formats the user can either open the data into an Excel
spreadsheet or open the database using MS Access.
System Requirements
Windows NT3.1 or, Windows 95 or later as your operating system.
1
An 80386 Processor or higher
A VGA monitor or one with higher screen resolution
Set the Display Properties for the Desktop area 800 by 600 pixels and small
fonts.
16 M of RAM
Comm port 38.4 kBaud or better
CD Drive
Installation
The COMLink files are contained on a CD which is shipped with the TTR. To
install the program, insert the COMLink CD into the CD drive
On Windows 95, Windows NT 4.0 or Windows XP: or Windows 7. Select
Run from the Taskbar Start menu, type the full name of the file (for
example, D:\Setup.exe), press the Enter key and follow the prompts.
On Windows NT 3.1: activate the Program Manager, select Run from the
File menu, type the full name of the file (for example, D:\Setup.exe), press
the Enter key and follow the prompts.
COMLINK is a 32-bit program and Win 3.1 won’t handle it.
1
Windows NT, Windows XP, Windows 95, and MS ACCESS are registered trademark of Microsoft Inc.
To Next Page
Loading...
Need help?
General
