145
Controls in detail
Control system
The selection marker is on the current
setting.
왘 Press button æ or ç to select
manual operation (
Manual
) or daytime
running lamp mode (
Constant
)
activated.
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U, the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
For more information on the daytime
running lamp mode, see “Lighting”
(
컄 page 114).
Set locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the vehi-
cle is unlocked with the SmartKey:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
앫 Front fog lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey, the lamps
will switch off automatically after approxi-
mately 40 seconds.
왘 Move the selection marker with
button æ or ç to the
Lighting
submenu.
i
For safety reasons, resetting the set-
tings to factory settings (
컄 page 135)
while driving will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Lighting - Cannot be completely
reset to factory sets. while
driving.
컄컄
To Next Page
Loading...
Need help?
General
