419
Practical hints
Towing the vehicle
Installing towing eye bolt
1 Cover on right side of front bumper.
2 Cover on right side of rear bumper.
Removing cover
왘 Press mark on cover 1 or 2 in
direction of arrows.
왘 Lift cover off to reveal the threaded
hole for towing eye bolt.
The towing eye bolt is supplied with the
tool kit (located in the compartment under-
neath the trunk floor).
왘 Screw towing eye bolt in to its stop and
tighten with lug wrench.
Reinstalling cover
왘 Fit cover 1 or 2 and snap into place.
i
If the battery is disconnected or
discharged
앫 the SmartKey will not turn in the
starter switch. For more informa-
tion, see “Battery” (
컄 page 411)
and “Jump starting” (
컄 page 415).
앫 the gear selector lever will remain
locked in position P. For informa-
tion on manually unlocking the
transmission gear selector lever
(
컄 page 388).
To Next Page
Loading...
Need help?
General
