240
Controls in detail
Power windows
Stopping windows
왘 Press or pull respective switch again.
Synchronizing power windows
The power windows must be
resynchronized each time
앫 after the battery has been
disconnected or discharged.
앫 if the power windows cannot be fully
opened (Express-open) or closed
(Express-close).
왘 Switch on the ignition (컄 page 33).
왘 Pull the power window switches until
the side windows are closed.
왘 Hold the switches for approximately
1 second.
The power windows are synchronized.
!
If the upward movement of the window
is blocked during the closing
procedure, the window will stop and
open slightly.
Remove the obstruction, pull the
switch again past the resistance point
and release.
If the window still does not close when
there is no obstruction, then pull and
hold the switch again. The side window
will then close without the obstruction
sensor function.
Warning! G
Driver’s door only:
If within 5 seconds you again pull the switch
past the resistance point and release, the
automatic reversal will not function.
To Next Page
Loading...
Need help?
General
