146
Controls in detail
Control system
왘 Press button j or k repeatedly
until the message
Surround lighting
appears in the multifunction display.
The selection marker is on the current
setting.
왘 Press button æ or ç to switch
the locator lighting function
On
.
왘 Turn the exterior lamp switch to
position U when exiting the vehicle
(
컄 page 114).
The locator lighting feature is
activated.
Set night security illumination
(Headlamps delayed shut-off)
Use this function to set whether or not the
exterior lamps illuminate during darkness
after exiting the vehicle and all doors
closed.
With the delayed shut-off feature activated
and the exterior lamp switch in
position U before the engine is turned
off, the following lamps will switch on
when the engine is turned off and remain
lit for approximately 15 seconds:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
앫 Front fog lamps
If after turning off the engine you do not
open a door or do not close an opened
door, the lamps will automatically switch
off after 60 seconds.
왘 Move the selection marker with
button æ or ç to the
Lighting
submenu.
왘 Press button j or k repeatedly
until the message
Hdlamp delay off
appears in the multifunction display.
The selection marker is on the current
setting.
i
You can reactivate this function within
10 minutes by opening a door.
컄컄
To Next Page
Loading...
Need help?
General
