More user manuals on ManualsBase.com
COMAND navigation system (last destinations)
150
X
Press n.
If your own address has already been
assigned, you will see the menu for starting
route guidance with your own address data.
X
Exiting menu: Select Back.
Destination memory list with input
characters
1
Input characters
In the destination memory list with input
characters 1, the input characters are
automatically activated.
X
Slide qm repeatedly until the input
characters disappear.
The list entry My Address is automatically
highlighted as long as you have not entered
any characters using the input characters.
If you have entered characters from the
list of input characters: Rotate ymz or
slide qm repeatedly until the list entry My
Address is highlighted.
X
Press n.
If your own address has already been
assigned, you will see the menu for starting
route guidance with your own address data.
X
Exiting menu: Select Back.
COMAND navigation system (last
destinations)
i
COMAND automatically saves the last
destinations for which the route calculation
was launched. It is stored in the “last
destinations” memory. If this memory is
full, COMAND deletes the oldest
destination. You can also save one
destination from the list of last destinations
in the destination memory. It will be saved
there permanently.
Saving a destination permanently in
the destination memory
X
Proceed as described in the “Saving a
destination from the list of last
destinations” section (Y page 146).
Control systems
To Next Page
Loading...
Need help?
General
