More user manuals on ManualsBase.com
COMAND system settings
92
Display
(Y page 92)
Time (Y page 92) Voice Control
(Y page 93)
Language
(Y page 94)
Favorite
(Y page 94)
Reset (Y page 95)
Display settings Time settings Voice Control
settings
Language settings Assign favorite
button
Reset COMAND to
factory settings
Display settings
Switching the display on or off
X
Switching off: Select Vehicle £
Display OFF.
X
Switching back on: Rotate ymz or slide
qmr.
Setting the display design
X
Select Vehicle £ System Settings
£ Display.
X
Select Day Mode, Night Mode or
Automatic.
i
In the Automatic setting, COMAND
analyzes the automatic vehicle light sensor
and switches between the display design
automatically.
Time settings
Setting the time
i
The correct time must be set for the
following navigation system functions to
operate correctly:
R
Route guidance on routes with time-
dependent traffic guidance
R
Calculation of estimated arrival time
X
Select Vehicle £ System Settings
£ Time £ Time.
X
Selecting hour or minute(s): Slide omp.
X
Setting value: Rotate ymz or slide qmr.
X
Saving setting: Press n.
i
The increment value for setting the
minutes depends on the situation. If GPS
reception is available, it is 30 minutes. If
GPS reception is not available, it is one
minute.
Setting the time zone and switching
between Daylight Saving Time and
standard time
i
The correct time zone and Daylight Saving
Time/standard time must be set for the
following navigation system functions to
operate correctly:
R
Route guidance on routes with time-
dependent traffic guidance
R
Calculation of estimated arrival time
X
Setting time zone: Select Vehicle £
System Settings £ Time £ Time
Zone.
The country list appears. The dot R in front
of a list entry indicates the current setting.
X
Select the country in which you are
currently driving.
A time zone list may also be displayed,
depending on the country selected.
X
Select desired time zone.
Control systems
To Next Page
Loading...
Need help?
General
