Vehicles with a tire pressure monitoring
system: If an emergency spare wheel is
installed, the tire pressure monitoring sys‐
tem cannot function reliably. For a few
minutes after an emergency spare wheel is
installed, the system may still display the tire
pressure of the removed wheel. Only restart
the system again when the emergency spare
wheel has been replaced with a new wheel.
Be sure to also observe the following further
related subjects:
R
Notes on tire pressure (/ page 306)
R
Tire and Loading Information placard
(/ page 313)
R
Tire pressure table (/ page 308)
R
Notes on installing tires (/ page 325)
Inflating the emergency spare wheel
*
NOTE Overheating due to the tire infla‐
tion compressor running too long
#
Do not run the tire inflation compressor
for longer than ten minutes without
interruption.
Requirements:
Comply with the manufacturer's safety notes on
the sticker of the emergency spare wheel and on
the tire inflation compressor.
#
Remove sticker with the label 50 mph
(80 km/h )from the tire inflation compressor
housing and affix it to the instrument cluster
within the driver's field of vision.
#
Remove the tire inflation compressor from
the storage space under the cargo compart‐
ment floor (/ page 287).
#
Pull filler hose 1 and plug 3 out of the tire
inflation compressor housing.
#
Insert plug 7 of filler hose 1 in the socket
on the tire inflation compressor and then
turn it until plug 7 engages.
#
Unscrew the cap from the valve on the emer‐
gency spare wheel.
#
Screw union nut 2 of filler hose 1 onto
valve .
#
Make sure on and off switch 4 of the tire
inflation compressor is set to 0.
#
Insert plug 3 in a socket in your vehicle.
R
12 V socket: (/ page 120)
Wheels and tires
335
To Next Page
Loading...
Need help?
General
