• Apply a generous coating of one of the following lubricants to the propeller shaft.
a - Propeller shaft
Tube Ref No. Description Where Used Part No.
Extreme Grease Propeller shaft 8M0071842
95
2-4-C with PTFE Propeller shaft 92-802859A 1
Engine Coupler
IMPORTANT: These engines are equipped with a sealed engine coupler. The sealed coupler and the shaft splines can be
lubricated without removing the sterndrive unit.
Lubricate the engine coupler splines through the grease fitting on the coupler by applying approximately 8–10 pumps of
Extreme Grease from a typical hand‑operated grease gun.
NOTE: If the boat is operated at idle for prolonged periods of time, the coupler should be lubricated on Bravo models every 50
hours.
Coupler shown separated for clarity
a - Grease fitting
Tube Ref No. Description Where Used Part No.
Extreme Grease Engine coupler and shaft splines 8M0071842
Driveshaft Extension Models
1. Lubricate the transom end grease fitting and engine end grease fitting by applying approximately 10–12 pumps of grease
from a typical hand‑operated grease gun.
a
a
20335
a
20861
Section 4 - Maintenance
Page 76 90-8M0145546 eng MAY 2018
To Next Page
Loading...
Need help?
General