Section 1 - General Information
90-8M0074777 eng MAY 2013 Page 9
6. Select the desired file format and then press Export.
7. Select Memory Card as the destination folder and select OK.
8. Name the backup file using the keypad and then press Enter.
Upgrading Vesselview
Important considerations before and during the upgrade process:
• Have you backed up your waypoints, routes and tracks?
• Each display must be upgraded individually; there is no automatic network feature to upgrade multiple VesselViews
simultaneously.
• Do not turn off the display or disrupt the power during the upgrade process.
• Do not remove the micro SD card during the upgrade process.
1. Verify that the ignition key is off and that VesselView is not turned on.
NOTE: Some installations may have the VesselView powered up with a dedicated circuit, rather than by the ignition key‑on
circuit.
IMPORTANT: VesselView must be turned off for more than 5 minutes before upgrading the software.
2. Insert the micro SD card into the card reader port all the way until it stays in place.
3. Turn the ignition key on and verify that the VesselView is on.
4. Allow the system to boot up. A screen will prompt you to upgrade or cancel.
5. Use the rotary knob to highlight the upgrade file and press the knob to confirm.
6. Do not turn the ignition key off, turn VesselView off, or remove the micro SD card while the software is uploading. The
upgrade process may take several minutes to complete.
To Next Page
Loading...
Need help?
General
