Security Code
113
3
Security Code
SECURITY CODE INFORMATION
To reduce the risk of theft, your audio unit was programmed with
a four-digit security code before the car left the factory. Once
activated, this code prevents the unit from functioning if it is
illegally removed from the car.
In addition, the audio unit is further protected by a time delay
penalty system: a one hour time delay is imposed after the third and
all subsequent code entry attempts.
Your car was supplied with a Security Information card. This card
contains a record of the four digit security code, as well as the
audio unit's unique serial number. The serial number is also
stamped into the metal side of the audio unit and, in the event of
theft, would confirm proof of ownership.
It is VERY IMPORTANT that you keep a safe record of the
security code and heed the following advice:
• NEVER keep a record of the security code in the car.
• If you lose your code number, contact an MG Rover dealer,
who will be able to obtain this information for you.
ENTERING THE SECURITY CODE
If power to the audio unit has been interrupted (car battery
disconnected, for example), the code MUST be entered before the
unit can be operated. Enter the code as follows:
• Switch on the radio (‘CODE’ appears in the display, followed
by ‘0000’).
• Press pre-set button 1 the required number of times to enter the
first digit of the code.
• Press pre-set button 2 the required number of times to enter the
second digit of the code.
• Repeat this process using pre-set buttons 3 and 4 to enter the
third and fourth digits of the code.
• When the correct code is displayed, press the control to
store the code.
NOTE: If three incorrect codes hare been entered, the first one hour time
delay period commences. During the delay period, ‘WAIT 1 H’ appears
in the display - DO NOT switch off. At the end of the delay period,
‘CODE’ reappears in the display and you can then enter the correct code.
To Next Page
Loading...
Need help?
General
