96
Cassette Player
Cassette Player
CASSETTE PLAYER CONTROLS (CC32 only)
1. Cassette compartment
Insert the tape with the open side to the right and push in carefully.
The radio mutes and tape play starts immediately
(display shows ‘CASSETTE’ then SIDE A’ or ‘SIDE B’).
At the end of either side of the tape, play automatically continues
in the opposite direction.
If the set is switched off during tape play, the cassette remains in
stand-by mode. Play resumes when the set is switched on again.
NOTE: Inserting a tape when the starter switch is turned off will switch
on the audio unit in tape mode, but playback will be limited to one hour.
2. Fast forward/rewind/tape reverse
During tape winding, ‘FORWARD’ or ‘REWIND’ shows in the
display.
• To forward or reverse wind, fully press either one of the two
buttons.
• To stop tape winding, half press the remaining (unlocked)
button. Tape play will automatically resume.
• To reverse the direction of tape play, half press both buttons
simultaneously.
3. Tape eject
Press FULLY to eject the cassette tape. The audio unit returns to
radio mode, selecting the waveband and frequency last in use.
4. Tape mode selection
Press briefly to change to or from radio or tape mode.
To change to radio reception during tape play, press either the tape
mode selection button, or the waveband selection button - tape
play will stop and the radio automatically selects the frequency last
in use. To return to tape play, press the mode button.
AS0036
AS0040
TRAF.RDSBND.TS
123 64 RPT 5 MIX
AUDIO X-BASS
SRC
MENU
D
M
S
2 413
To Next Page
Loading...
Need help?
General
