64
Starting & Driving
ALL MODELS
Warming up
In the interest of fuel economy, it is advisable to drive the car soon
after starting. Remember that harsh acceleration, or labouring the
engine before the normal operational temperature has been
reached, can damage the engine.
Parking
After bringing the car to a stop, ALWAYS apply the handbrake
and select neutral (‘P’ for cars with automatic transmission), before
releasing the foot brake and switching off the engine.
After switching off, cooling fans may continue rotating for
several minutes to prevent the engine from overheating. In
some circumstances, the cooling fan may not start rotating until
after the engine is switched off. If the bonnet is opened, keep clear of
fans whenever the engine is warm.
Towing - switching off
After periods of strenuous towing (particularly at high altitude or
in hot weather), it is good practice to allow the engine to idle for
a few minutes before switching off. This will enable the engine
cooling system to continue operating for a while in order to reduce
underbonnet heat.
RUNNING-IN
The engine, gearbox, brakes and tyres need time to ‘bed-in’ and
adjust to the demands of everyday motoring. During the first
1,000 km, it is essential that you drive with consideration for the
running-in process and heed the following advice:
• Do not allow the engine to exceed 3,000 rev/min in any gear.
• Do not operate at full throttle in any gear.
• Do not allow the engine to labour in any gear.
• Avoid heavy braking where possible.
After the running-in distance has been completed, engine speeds
can be gradually increased.
To Next Page
Loading...
Need help?
General
