Wipers & Washers
79
2
Wipers & Washers
WIPER CONTROLS
The wipers and washers will only operate when the starter switch
is turned to position ‘II’.
Rotate the end of the lever to select different wiper speeds
1. Intermittent wipe
2. Normal speed wipe
3. Fast speed wipe
NOTE: If reverse gear is selected while the front wipers are operating (at
any speed setting), the rear screen wiper will operate automatically for three
wipes.
Single wipe
Pull the lever down and release immediately.
NOTE: With the lever held down, the wipers will operate at high speed
until it is released.
Windscreen washer
Pull the lever towards the steering wheel. The windscreen washers
will operate for as long as the lever is held in this position.
NOTE: The wipers operate automatically during windscreen washing.
On cars fitted with heated windscreen washer jets, the heater
prevents the jets from being rendered inoperative by freezing, but
does not prevent the water from freezing on the screen; therefore,
a suitable screenwash must still be added to the washer reservoir
(see ‘WINDSCREEN WASHER TOP-UP’, page 130).
IMPORTANT
• DO NOT operate the wipers on a dry screen.
• In freezing or very hot conditions, ensure that the blades are not
frozen or stuck to the glass before being operated.
• In winter, remove snow or ice from around the arms and blades,
including the wiped area of the screen.
HB0095
1
2
3
To Next Page
Loading...
Need help?
General
