Technical Information
62
CVA615 Coffee System
4. Clean the Brew Unit thoroughly under running warm water
without detergent.
5. Rub away coffee residues from the steel filters with a sponge.
6. Dry the funnel to prevent ground coffee from sticking.
7. After cleaning press "PRESS".
8. Remove the Waste Container (if re-installed).
Figure 5-20: Brew unit installation
8. Push the brew unit in the track straight into the appliance
without pressing "PRESS" until it clicks in place
(see figure 5-20).
5.24 Brew Unit – Filter Cleaning
1. Remove the Brew Unit.
2. Wipe away coffee residues from the steel filter in the funnel of
the brew unit with a sponge.
3. The filters can be removed for thorough cleaning.
4. Fit a 5mm allen wrench to the connection point in the brew unit.
Turn counterclockwise while supporting the chrome filter from
below. Remove the filter by lifting it from the brew unit.
5. Access the second filter by placing a long shaft Philips
Screwdriver through the center of the funnel and remove the
screw in the center of the filter.
6. Manually move the brew unit into the “brew position”.
7. Turn brew upside down – filter will fall out.
8. Clean both sides of the filter with hot water and dry.
9. Re-install the second filter back in position.
10. Manually move the Brew Unit to the “home position”
11. Re-install the Philips screw in the center of the filter.
12. Return the first filter to the brew unit and secure by turning the
allen wrench clockwise.
To Next Page
Loading...
Need help?
General
