Technical Information
74
CVA615 Coffee System
20. Remove the knobs from the Grinder Slide Controls.
21. Remove the Adjustment Slide Switch Frame (5.4).
22. Position the Grinder as necessary to access the Drive Cover
and Drive Unit Retaining Screws. Refer to Figure 5-34 for the
location of the screws.
23. Remove the two Upper Front Plate Assembly Retaining Screws
– as shown in Figure 5-35.
24. Remove all remaining screws from the Front Plate Assembly.
Lift upward on the Front Plate Assembly to access the screws
near the bottom of the plate. Use Figure 5-32 to locate all
screws.
Figure 5-35: Upper Front Plate Assembly Retaining Screws.
25. Move the Drive Assembly Cover toward the rear wall of the
appliance.
26. Move the Drive Assembly back while lifting upward to remove it
from the appliance. Use caution - a short length of wiring.
To Next Page
Loading...
Need help?
General
