Technical Information
85
5.39 Grinder Assembly - Basic Setting
Refer to Figure 5-47.
Note
The Grinder Ring (6), and Grinder Cone, (6), should be replaced
together.
1. Install the Felt Ring (11).
2. Install the carriers (10).
3. Install the mounting (7).
4. Install the springs (9).
5. Install the balls (8).
6. Install the Grinding Cone (6), ensure the balls are seated.
7. Install the washer (3).
8. Install the Intake Worm Gear (2), press down, and turn until the
coupling engages.
9. Tighten the Grinding Cone Screw (1) counter clockwise.
(Ensure the intake worm gear coupling has engaged properly).
Note
Before setting the grinder, remove all coffee from the grinder.
10. Fit the bracket (3).
11. The blue marking on the carrier (2), has the same position as
the blue marking on the adjustment ring (item 1); both point
toward the front of the appliance.
12. Turn the Adjustment Ring Clockwise as far as possible.
13. Turn the Adjustment Ring Counterclockwise by 6 settings so
that the Adjustment Lever can be secured at a mid setting.
14. Fit the Adjustment Lever such that the grinder is set to a
medium grinding grade.
15. Tighten the Adjustment Lever Fixing Screws.
16. Push on the handle.
To Next Page
Loading...
Need help?
General
