Frequently asked questions
155
The following faults can be corrected without contacting the Miele Service Depart-
ment.
If in doubt, please contact Miele.
Risk of injury! Improperly performed installation, maintenance or repair work
can pose a serious danger to users of the appliance.
Installation, maintenance and repairs may only be carried out by Miele autho-
rized technicians.
Do not attempt to open the housing.
Problem Possible cause and solution
You cannot turn the ap-
pliance on.
The circuit breaker has tripped.
Reset the circuit breaker (see data plate for the
correct fuse rating).
There may be a technical fault.
Disconnect the appliance from the power supply
for approx. 1minute:
– tripping the relevant circuit breaker or screwing
the fuse out completely, or
– tripping the ground fault circuit interrupter
(GFCI).
If the steam oven still will not turn on, contact a
qualified electrician or Miele Service.
The steam oven does
not heat up.
Demonstration mode is active
Deactivate Demo mode (see "Settings – Show-
room Program").
The fan can still be
heard after the appli-
ance has been turned
off.
The fan is still running.
The appliance is fitted with a fan which removes
steam from the oven. The fan will continue to run for
a while after the appliance has been switched off. It
will turn itself off automatically after a while.
A humming sound can
be heard after switching
on the appliance, during
operation and after
turning off the appli-
ance.
This is not a fault. It is made by water being pumped
through the system.
To Next Page
Loading...
Need help?
General
