Technical Information
9
T1500 Series Clothes Dryers
2.0 Installation
Do not drink the condensed water.
Keep the area around the air intake (Toekick) and surrounding
areas free from lint, dust and dirt. This area should not be
blocked (i.e. Toekick) this will prevent sufficient intake of air and
effect appliance operation.
Do not reach into the Dryer if the Drum is moving.
The appliance should be level to ensure proper operation.
A Dryer can be placed on top of a Miele Washer; for a stacked
installation. An approved Miele stacking kit must be used.
2.1 Electrical Requirements
120/240 (208) Volt, 60Hz., 15 Amp breaker
Dryer is equipped with a 4 wire power cord equipped with a
NEMA 14-30 plug, for connection to a NEMA 14-30 receptacle.
Note
If you do not have a dedicated 15 Amp circuit for this appliance, but
have a NEMA 14-20 or NEMA 14-30, 240V, 30 Amp outlet, you
may be able to use a Miele “Easy Installation Kit” to simplify the
electrical connection. For further information refer to Electrical
Information pages in the Installation Manual.
Do not cutoff / remove the Plug from the Power Cord.
To Next Page
Loading...
Need help?
General
