−33−−32−
・
When returning to the screen mentioned below from each setting screen, operate the following buttons or switches.
■Return to Main screen …
Menu
button
■Return to the last previous screen …
Back
button
■Return to TOP screen …
Run/Stop
switch
・
When the
Back
button is tapped without tapping the
Set
button on the way of setting, contents of the setting are invalidated, and the display returns to the last previous
screen. If the
Run/Stop
switch is pushed on the way of setting, contents of the setting are invalidated, the setting mode is terminated and the display returns to the TOP
screen.
・
If no button is operated for approx. 5 minutes on the way of se
tting each item, the display returns to the TOP screen automatically. Contents of the setting on the way become
invalid.
・
Message “Invalid request” may be displayed when a button is pushed.
This is not a fault but it is because the button is set to the Prohibition.
・
It is necessary to stop the air conditioner by pushing the
Run/Stop
switch before starting the following settings.
If the Set button is tapped on the menu screen while the air conditioner is operating, the message “Invalid request.” is displa
yed.
■Individual ap control ■Anti draft setting ■Select the language
■Energy-saving setting ■Administrator settings
Cautions for each setting screen
1
Tap the
Menu
button on the TOP screen and select
Energy-saving setting
. The Energy-saving setting menu screen is
displayed.
2
When the Energy-saving setting screen is displayed, select a desired item.
・Sleep timer
・Peak-cut timer
・Automatic temp set back
Motion sensor control
Energy-saving setting [Administrator password]
■Sleep timer
Stops operation when the amount of time set has elapsed since the start of each operation.
1
Tap the
Menu
button on the TOP screen and select
Energy-saving setting
⇒
Sleep timer
. The Sleep timer screen
is displayed.
2
Select a desired time with
①
▲
▼
buttons. Setting range: 30 to 240 minutes, at 10-min intervals.
3
Tap the
②
State
button to switch between “State Enable” and “State Disable”.
・
“Enable”: operation stops at the set time every time.
・
“Disable”: the sleep timer does not operate.
Unless the Sleep timer is used, set at the “State Disable”.
4
The
③
Zones button is displayed when performing zone settings. Tapping the
③
Zones button makes it possible to
perform zone operation settings at the time of timer working. (The Zones
button is not displayed when not performing zone
settings. Proceed to step 6 .)
A/C will stop at the set minutes later.
2
3
1
5. Settings and operations
5
Tapping the
Zones
button will transition to the zone operation setting screen. Set ④ No setting
/ ON
/ OFF (No setting/OPEN/
CLOSE) for each zone during timer operation.
→
No setting
→
ON
→
OFF
Setting No setting
will operate in the previous zone state at the time of timer working.
After the setting, tap the ⑤ Set
button.
The display returns to the previous screen.
5
4
PJZ012A180_EN.indd 33 2019/03/29 11:33:27
To Next Page
Loading...
Need help?
General
