HEATER AND MANUAL AIR CONDITIONER – On-vehicle Service
55-10
REPLENISHING SYSTEM
1. Connect the charging hose (blue) to the adapter valve
1 with the handle fully turned back (valve closed).
2. Connect the charging hose (blue) to the quick joint 2
and to the low pressure service valve.
Caution
Never connect to the high-pressure side since
otherwise the refrigerant could flow back.
3. Open and close the valve by operating the handle of
the adapter valve 1 to bleed air from inside the charging
hose.
4. With the handle turned back all the way (valve open),
install the charging valve to the service van.
5. Tighten the handle of the charging valve (valve closed)
and puncture the service can.
6. Install the charging valve to the adapter valve 1 and turn
back the handle all the way (valve open).
7. Start the engine.
8. Operate the A/C and set to the lowest temperature (MAX.
COOL).
9. Fix the engine speed at 1,500 r/min.
10. Tighten the handle of the adapter valve 1 (valve open).
Replenish the system with refrigerant while checking the
level through the sight glass.
After charging with refrigerant, turn the handles of the
charging valve and the adapter valve 1 all the way back
(valve closed), then remove the quick joint 2.
NOTE
If the service can is not emptied completely, keep the
handles of the charging valve and adaptor valve closed
for the next charging.
Charging
valve
Adapter valve
(for low pressure)
Charging hose
(blue)
R134a
Service
can
Quick joint
(for low pressure)
Low-
pressure
service
valve
High-
pressure
service
valve
Air conditioning system
To Next Page
Loading...
Need help?
General
