Figure 17: Radio to Radio Cloning
1 Turn the radio off.
2 Unplug any cables from the SUC.
3 Plug one side of the cloning cable mini USB
connector to the first SUC, and the other end to the
second SUC.
NOTE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
4 Turn on the Target Radio and place it into one of the
SUCs.
5 To turn on the Source Radio, press PTT→Volume
Down buttons at the same time for three seconds.
You hear Cloning Mode beeps, and "Cloning Mode,
Serial" voice prompt from your radio.
6 For the Source Radio, power on the radio with the
following sequence:
1 Press PTT→Volume Down buttons at the same
time while turning the radio on. Wait three
seconds before releasing the buttons, and you
hear “Clone Mode Serial” voice prompt from your
radio.
English
101
To Next Page
Loading...
Need help?
General
