Motorola solutions Curve Series User Manual

2 Place the Source Radio in its SUC. Press and
release the Volume Up button.
You hear "Pass" or "Fail" voice prompt from your
Source Radio.
7 To exit the Clone Mode when the process is
completed, press the Power button, or long press
the PTT button.
13.4
Troubleshooting Cloning Mode
In the event that cloning fails, perform each of the following
steps before attempting to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-
Unit Chargers (SUC and if the cable is switched to
“Cloning”.
3 Ensure that there is no debris in the charging tray
or on the radio contacts and the radio contact is
touching the SUC or MUC contact firmly.
4 Ensure that the Target Radio is turned on.
5 Ensure that the Source Radio is in cloning mode.
6
NOTE:
This cloning cable is designed to operate
only with compatible Motorola Solutions SUC,
PMLN7140_.
When ordering cloning cable kit, refer to part number
HKKN4028_ For more information about the accessories,
see Accessories on page 114
13.5
Cloning Mode Using Wireless
PROFILE ID Number
The PROFILE ID Number Wireless Cloning feature is
useful when you want to clone the PROFILE ID Number
for all the radios in your fleet, but you do not want to clone
particular radio settings that may be unique for each radio
such as Top button configuration, MIC Gain, Radio Name.
Wireless PROFILE ID preserves each user radio setup, but
still ensure that all radios are under the same PROFILE
English
102

Motorola solutions Curve Series Specifications

General

Brand	Motorola solutions
Model	Curve Series
Category	Two-Way Radio
Language	English