6.2.7.2
Saving a Channel in the Dynamic Zone from List Selection
Prerequisites: To perform this operation, the radio must be in the Dynamic Zone.
Procedure:
1 or to ZnPr. Press the Menu Select button directly below ZnPr to enter the Program Zone
screen.
2 Press the Menu Select button directly below Edit.
The display shows Search Options screen.
3
or to List Selection. Press the Menu Select button directly below SEL .
The display shows Select Zone screen.
4
or to the required zone. Press the Menu Select button directly below SEL .
The display shows Select Chan screen.
5 or to the required channel. Press the Menu Select button directly below SEL .
The display shows Channel updated.
6 Press the Menu Select button directly below Exit to return to Home screen.
6.2.7.3
Deleting a Channel in the Dynamic Zone
Prerequisites: To perform this operation, the radio must be in the Dynamic Zone.
Procedure:
1
or to ZnPr then press the Menu Select button directly below ZnPr to enter Program Zone
screen.
The display shows the dynamic channels list.
2 or to the saved dynamic channel then press the Menu Select button directly below Del.
The display shows Channel deleted screen.
3 Press the Menu Select button below Exit to return to Home screen.
The Home screen shows <Dynamic Zone Channels>.
If the channel deleted is the Home channel, the Home screen shows <Zone Name>“Blank”.
6.3
Multiple Control Head Features
This feature allows your transceiver to control the combinations of control heads on APX Mobile.
You can use the Controller Area Network (CAN) cables to connect in any configuration that does not
exceed 131 feet. For further information, refer to the following Installation Manuals:
• 6878215A01 APX Mobile Radios and Control Heads Installation Manual
• MN003109A01 APX 8500 Mobile Radio Installation Manual
• MN005720A01 Enhanced Single Band Mobile Radio Installation Manual
6875947M01-HM
Advanced Features
44
To Next Page
Loading...
Need help?
General
