mycom SCV Series User Manual

2205Q2JE-HO-S6-N_2020.01.
Chapter 5 Maintenance and Inspection
SCV-series Screw Compressor 5.4 Disassembly and Inspection
5-15
5.4.1.1 Disassembly
■ In the Case of Removing the Wiring only
When removing the wiring of the unloader indicator upon removing the compressor, it is necessary
to remove the cover as the indicator has a terminal block for the wiring. Perform the work according
to the following procedure, and after removing the wires, attach the cover to them for protection.
a) By removing the three hexagon socket head cap screws [147] that are used to fasten the
indicator cover [146], the cover can be removed.
b) The indicator cover will be removed with the glass [141] and spacer [142] attached. While the
glass and spacer are glued, be careful not to drop these as they may be separated from the
cover.
c) Remove the wiring. Be careful not to lose the phillips screws [133] of the terminal block [132].
Figure 5-4 Traditional Standard type Unloader Indicator Assembly
Removal of the Indicator Cover

mycom SCV Series Specifications

General

Brand	mycom
Model	SCV Series
Category	Air Compressor
Language	English