National Instruments cRIO-904 Series User Manual

Figure 82. Frequency Generator Block Diagram
100 kHz Timebase
20 MHz Timebase
Frequency
Output
Timebase
FREQ OUT
Divisor
(1–16)
Frequency Generator
÷ 2
The frequency generator generates the Frequency Output signal. The Frequency Output signal
is the Frequency Output Timebase divided by a number you select from 1 to 16. The
Frequency Output Timebase can be either the 20 MHz Timebase, the 20 MHz Timebase
divided by 2, or the 100 kHz Timebase.
The duty cycle of Frequency Output is 50% if the divider is either 1 or an even number. For an
odd divider, suppose the divider is set to D. In this case, Frequency Output is low for (D + 1)/2
cycles and high for (D - 1)/2 cycles of the Frequency Output Timebase.
The following figure shows the output waveform of the frequency generator when the divider
is set to 5.
Figure 83. Frequency Generator Output Waveform
Frequency
Output
Timebase
FREQ OUT
(Divisor = 5)
Frequency Output can be routed out to any PFI terminal. All PFI terminals are set to high-
impedance at startup. The FREQ OUT signal also can be routed to many internal timing
signals.
In software, program the frequency generator as you would program one of the counters for
pulse train generation.
For information about connecting counter signals, refer to the Default Counter/Timer Routing
section.
Frequency Division
The counters can generate a signal with a frequency that is a fraction of an input signal. This
function is equivalent to continuous pulse train generation. Refer to the Continuous Pulse
Train Generation section for detailed information.
For information about connecting counter signals, refer to the Default Counter/Timer Routing
section.
104 | ni.com | cRIO-904x User Manual

National Instruments cRIO-904 Series Specifications

General

Brand	National Instruments
Model	cRIO-904 Series
Category	Controller
Language	English