EasyManuals Logo
Home>National Instruments>Computer Hardware>PCI-6035E

National Instruments PCI-6035E User Manual

National Instruments PCI-6035E
265 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
Chapter 9 Bus Interface
© National Instruments Corporation 9-3 E Series User Manual
Changing Data Transfer Methods between DMA and IRQ
There are a limited number of DMA channels per device. Refer to
Appendix A,
Device-Specific Information, for the specifications document
for your device. Each operation (for example, AI, AO, and so on) that
requires a DMA channel uses that method until all of the DMA channels
are used. Once all of the DMA channels are used, you will get an error if
you try to run another operation requesting a DMA channel. If appropriate,
you can change one of the operations to use interrupts. For NI-DAQmx, use
the Data Transfer Mechanism property node. For Traditional NI-DAQ
(Legacy), use the Set DAQ Device Information VI or function.

Table of Contents

Other manuals for National Instruments PCI-6035E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the National Instruments PCI-6035E and is the answer not in the manual?

National Instruments PCI-6035E Specifications

General IconGeneral
BrandNational Instruments
ModelPCI-6035E
CategoryComputer Hardware
LanguageEnglish

Related product manuals