Chapter 1 DAQ System Overview
E Series User Manual 1-6 ni.com
SCC
SCC is a front-end signal conditioning system for E Series plug-in data
acquisition devices. A SCC system consists of a shielded carrier that holds
up to 20 single or dual-channel SCC modules for conditioning
thermocouples and other transducers. SCC is designed for small
measurement systems where you need only a few channels of each signal
type, or for portable applications. SCC systems also offer the most
comprehensive and flexible signal connectivity options.
System features include:
• Modular architecture—Select your measurement technology on a
per-channel basis
• Small-channel systems—Condition up to 16 analog input and eight
digital I/O lines
• Low-profile/portable—Integrates well with other laptop computer
measurement technologies
• High bandwidth—Acquire signals at rates up to 1.25 MHz
• Connectivity—Incorporates panelette technology to offer custom
connectivity to thermocouple, BNC, LEMO
™
(B Series), and MIL
Spec connectors
5B Series
5B is a front-end signal conditioning system for plug-in data acquisition
devices. A 5B system consists of eight or 16 single-channel modules that
plug into a backplane for conditioning thermocouples and other analog
signals. National Instruments offers a complete line of 5B modules,
carriers, backplanes, and accessories.
Note For more information about SCXI, SCC, and 5B series products, refer to ni.com/
signalconditioning.
Cables and Accessories
NI offers a variety of products to use with E Series devices, such as:
• Cables and cable assemblies, shielded and ribbon
• Connector blocks, shielded and unshielded 50- and 68-pin screw
terminals
• RTSI bus cables
To Next Page
Loading...
Need help?
General
