Appendix A Device-Specific Information
© National Instruments Corporation A-69 E Series User Manual
NI 6040E Family Specifications
Refer to the NI 6040E Family Specifications for more detailed information
on the devices.
NI 6052E Family
DAQPad-6052E
The DAQPad-6052E is a Plug-and-Play, multifunction AI, AO, DIO, and
TIO device.
The DAQPad-6052E features the following:
• 16 AI channels (eight differential) with 16-bit resolution
• Two AO channels with 16-bit resolution
• Eight lines of TTL-compatible DIO
• Two 24-bit counter/timers for TIO
• A 68-pin I/O connector
Note The BNC version of the DAQPad-6052E has a 30-pin I/O connector.
The NI DAQPad-6052E for 1394 is a high-performance, switchless,
jumperless, hot-pluggable DAQ device. The 1394 interface automatically
handles the assignment of all host resources and allows you to install the
device without powering off the computer. You can plug up to 64 National
Instruments DAQ devices into a single computer using 1394, although you
will run out of bus bandwidth if all devices operate at full rate. The
NI DAQPad-6052E for 1394 provides up to 250 V of DC functional
isolation from the computer.
The NI DAQPad-6052E for 1394 has an onboard watchdog timer that
continuously resets the device until the device successfully enumerates
with the host operating system and the device driver initiates transactions
to the device. To avoid continuous resets, make sure the device and host
computer are powered on, the 1394 cable is attached to the host computer,
and the device drivers are installed.
To Next Page
Loading...
Need help?
General
