© National Instruments | 2-11
RMC-8356 User Manual
DMI Link ASPM Control
Use this feature to set the ASPM (Active State Power Management) state on the SA (System
Agent) side of the DMI Link. The options are Disabled and L1.
DMI Extended Sync Control
Use this feature to enable or disable the DMI extended synchronization. The options are
Disabled and Enabled.
DMI De-Emphasis Control
Use this feature to configure the De-emphasis control on DMI. The options are -6dB and
-3.5dB.
PEG Port Configuration
SLOT6 Max Link Speed
This feature allows the user to select PCI-E support for the device installed on SLOT6.
The options are Auto, Gen 1, Gen 2, and Gen 3.
SLOT6 Max Payload Size
Use this feature to select the PEG0 maximum payload size. The options are Auto, 128 TLP,
and 256 TLP.
SLOT6 Power Limit Value
Use this feature to set the upper limit on the power supplied by the PCIE slot. Press + or -
on your keyboard to change this value. The default setting is 75.
SLOT6 Power Limit Scale
Use this feature to select the scale used for the slot power limit value. The options are 1.0x,
0.1x, 0.01x, and 0.001x.
Program PCIe ASPM After OPROM
PCIe ASPM, the Active State Power Management for PCI-Express slots, is a power
management protocol used to manage power consumption of serial-link devices installed on
PCI-Exp slots during a prolonged off-peak time. If this item is set to Enabled, PCI-E
ASMP
will be programmed after OPROM. If this item is set to Disabled, the PCI-E ASPM
will be
programmed before OPROM. The options are Disabled and Enabled.
Memory Configuration
The following memory information will display:
• Memory RC Version
• Memory Frequency
• Total Memory
To Next Page
Loading...
Need help?
General
