Compliance
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for electromagnetic
compatibility (EMC) stated in the product specifications. These requirements and limits provide reasonable
protection against harmful interference when the product is operated in the intended operational
electromagnetic environment.
This product is intended for use in locations other than residential locations. However, harmful interference
may occur in some installations, when the product is connected to a peripheral device or test object, or if the
product is used in residential areas. To minimize interference with radio and television reception and prevent
unacceptable performance degradation, install and use this product in strict accordance with the instructions
in the product documentation.
If this hardware does cause interference with licensed radio communications services or other nearby
electronics, which can be determined by turning the hardware off and on, you are encouraged to try to correct
the interference by one or more of the following measures:
• Reorient the antenna of the receiver (the device suffering interference).
• Relocate the transmitter (the device generating interference) with respect to the receiver.
• Plug the transmitter into a different outlet so that the transmitter and the receiver are on different branch
circuits.
Furthermore, any modifications to the product not expressly approved by National Instruments could void
your authority to operate it under your local regulatory rules.
Caution To ensure the specified EMC performance, operate this product only with shielded
cables and accessories. Note that the input AC power cable may be unshielded.
To Next Page
Loading...
Need help?
General
