To check the package contents:
1.
Place the container on a clean flat surface, and cut all straps securing the container.
2.
Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4.
Verify that the package contains the following items:
DescriptionLetter
Switch (in the previous figure, model GS724TPv2 is shown)a
Power cordb
Rubber footpads for tabletop installationc
Rubber protection caps, which are already installed in the SFP sockets. If you install
an SFP transceiver module, you must remove the cap from the SFP socket.
d
Screws for rack mountinge
Brackets for rack mountingf
Installation guideg
5.
If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
Step 4: Mount or place the switch
You can mount the switch in a standard 19-inch (48.26-centimeter) network equipment
rack or place the switch on a flat surface.
Mount the switch in a rack
To install the switch in a rack, you need the 19-inch rack-mount kit supplied with the
switch.
To install the switch in a rack:
1.
Attach the supplied mounting brackets to the side of the switch.
2. Insert the screws provided in the product package through each bracket and into
the bracket mounting holes in the switch.
3. Tighten the screws with a No. 2 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two
pan-head screws with nylon washers through each bracket and into the rack.
Hardware Installation Guide27Installation
24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
To Next Page
Loading...
Need help?
General