To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
Use port 25F or 26F.
2.
Press firmly on the flange of the module to seat it securely into the connector.
Step 6: Connect devices to the switch’s RJ-45
ports
All RJ-45 ports on the switch support PoE+. For application examples and information
about PoE, see Applications on page 19.
The switch supports Auto Uplink technology, which allows you to attach devices using
either straight-through or crossover cables. Use a Category 5 (Cat 5), Cat 5e, or Cat 6
cable that is terminated with an RJ-45 connector.
Note: Ethernet specifications limit the cable length between the switch and the attached
device to 328 feet (100 meters).
To connect devices to the switch’s RJ-45 ports:
1. Attach PoE and non-PoE devices to the switch.
2.
Verify that all cables are installed correctly.
Hardware Installation Guide29Installation
24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
To Next Page
Loading...
Need help?
General