NETGEAR R6400v2 User Manual

Manage Your Network
140
AC1750 Smart WiFi Router
3. Enter the router user name and password.
The user name is admin.
The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADV
ANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
5. Click the Add button.
6. In the Route Name field, type a name for this static route (for identification purposes only).
7. Select the Private check box if you want to limit access to the LAN only
.
If the Private check box is selected, the static route is not reported in RIP
.
8. Select the Active check box to make this route ef
fective.
9. T
ype the IP address of the final destination.
10. T
ype the IP subnet mask for this destination.
If the destination is a single host, type 255.255.255.255.
11. T
ype the gateway IP address.
This address must be on the same LAN segment as the router.
12. T
ype a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually
, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
13. Click the Apply button.
The static route is added.
Edit a Static Route
 To edit a static route:
1. Launch a web browser from a computer or mobile device that is connected to the
network.
2. Enter http://www
.routerlogin.net or http://www.routerlogin.com in the address field of the
web browser.

NETGEAR R6400v2 Specifications

General

Brand	NETGEAR
Model	R6400v2
Category	Network Router
Language	English