Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Wireless Configuration 5-9
v3.0, December 2005
• If WPA-PSK or WPA2-PSK Authentication is Used:
– Passphrase: ______________________________
These characters are case sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network will not connect unless they are set to WPA-PSK as well and are configured
with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the
network will not connect unless they are aslo set to WPA2-PSK and are configured with
the correct Passphrase.
Use the procedures described in the following sections to configure the WGT624 v3. Store this
information in a safe place.
Default Factory Settings
When you first receive your WGT624 v3, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGT624 v3 wireless router, use the procedures below to customize any of the settings to better
meet your networking needs.
FEATURE DEFAULT FACTORY SETTINGS
Wireless Access Point Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR
11b/g RF Channel 11
Mode g and b
Authentication Type Open System
WEP Disabled
To Next Page
Loading...
Need help?
General
