To Next Page

To Previous Page

2) Remove and

discard the

cardboard label core

which should be

located on the Label

Roll Spool (b)

making sure NOT to

throw out the Label

Roll Spool (b). Make

sure to also discard

any excess labels

and/or backing paper

along the label path.

The label path is

shown in red on the

Installation sticker in

the cassette drawer.

Installation Labels:

Once you have followed the

instructions for removing labels you

can install a new label roll by taking

the new label roll and remove about

30 cm (approx. 12”) of labels from the

backing paper of the new label roll

and then do the following:

1) Place the new label roll onto the

Label Roll Spool (b).

2) Thread the backing paper through the Pressure Plate (c).

3) Next, thread the backing paper between the La

bel Guide bobbin (g)

and (h).

Then, thread the backing paper over the Platen (d) and over the

Label Guide bobbin (i) so that the backing paper is

NOT between

Platen (d) and the Label Guide bobbin (i).

Nets NETS User Manual

Questions and Answers: