72
8-1. Self Test
The NETS has a several self test features that can help you determine
if things are working correctly. However, these features should only be
used by an ACOM Dealer. Details regarding these features are located
in the NETS Service Manual (Calibration mode: C1-2) available ONLY
to ACOM Dealers.
8-2. Print PLU
The NETS can display or print a list of all the scale’s PLUs. This can
be very helpful when you do not have the NETS Software Package
or do not have access to a computer. Whenever you are generating
a printout of the PLU list, you want to make sure that your scale is
loaded with enough labels to complete the job. The scale will print
a verification label for every PLU in the range that you specify, so it
is recommended that you use a small label format when you do this.
When you display the PLU, you cannot specify a range; therefore, you
must toggle through ALL of the PLUs or press
to finish
prematurely. We recommend that you purchase the NETS Software
Package if you are going to be dealing with over 100 PLUs.
To print the PLU List:
1. Enter ‘Main menu’, and follow 2 steps below.
2. Press
.
3. Make sure that the printer is loaded with enough labels. Using the
numeric keys, type the PLU number that you want the list to start from.
To Next Page
Loading...
General